Configure raspberry pi xscreensaver9/28/2023 On Stretch Lite (with monitor and keyboard connected) use the instruction sudo ifconfig and look under wlan0>inet addr. Alternatively, if using the full version of stretch, this can be found by connecting a monitor, mouse and keyboard and click the internet icon at the top right of the desktop. When it is running find the IP address by logging onto your router. Also connect the WiFi dongle, if necessary via the USB hub. To do this - copy the following into Notepad:Ĭtrl_interface=DIR=/var/run/wpa_supplicant GROUP=netdevĮdit the YOUR_NETWORK_NAME and YOUR_PASSWORD (keep the "") and save to the ‘Boot’ part of the SD card as wpa_nfĮject the card and plug it into the Pi. This needs the network name and password adding in a specific file. If using a Pi Zero (or ZeroW) we need to get the WiFi working to enable remote setup. This enables the Pi to be driven remotely and set up from a PC and also to take advantage of copy and paste of the text listed here. Etcher is free and downloadable from and is straightforward to run:Īfter the card has been flashed add a blank file called ‘SSH’ to ‘Boot’. Then run Etcher to download the image to an SD card. The version available at the time of writing was October 2018 but others should work fine. The process will use remote setup of the Pi as in most cases this is easier – and can avoid the need for a keyboard.įirst download Raspbian Stretch or Stretch Lite from ![]() The latter uses less memory but the former may be needed if the PI is being used for something else as well. The system will work from both the full Raspbian Stretch install and from Stretch Lite. Text in bold italics has to be entered during the setup and can in most cases be copied and pasted – that saves a load of time. The instructions here should allow a novice (or more experienced) to get this running from scratch. See: instructable This has the big plus of being thin and being able to fit into a real picture frame.Īll the software/firmware required is free.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |